User manual

52
User Manual
BritePort 8120
LAN, will be used. That is, you only need the Primary IP Address, which is the default
IP address 192.168.1.1, to access your BritePort 8120. Assigning the Secondary IP
Address to your BritePort 8120 only if you have two subnets set up on your LAN.
DHCP Server
This page allows you to
configure the DHCP Server.
(see Figure 4-16) You can
select the DHCP Server to be
either Disabled or Enabled.
If you wish to define its Relay
Agent, your default DHCP
Server is set to be enabled.
Your BritePort 8120 supports
DHCP server on your Primary
LAN. To configure, select the
Enabled option and click Configure to open the “DHCP Server” configuration page.
You can define the Start/End IP Addresses, Lease Time, Default Gateway, and
Domain Name Servers. Once complete, click Apply to confirm all the settings.
WAN Configuration (WAN)
Information shows in WAN
Configuration (see Figure 4-
17) is also linked to the “WAN
Connection” page under
Status. (see Figure 4-6) You
can modify and delete the
current PVC (Permanent
Virtual Circuit) and also create
a new PVC. To modify a
PVC, click the Modify link to
open the “Modify ATM PVC”
page, which allows you to
configure the detail properties,
such as ATM Properties and
IP Configuration, of the selected PVC. (refer to Figure 4-7)
Figure 4-16
Figure 4-17