User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
User Manual
BritePort 8120
45
WAN Connection
The Wan Connection provides information about the type of WAN data encapsulation
is used between your BritePort 8120 and the DSL service provider. The page, refer to
Figure 4-6, also provides other information such as Local WAN IP and VPI/VCI
values.
Similar to other pages under
Status, all data on the “WAN
Connection” page are
periodically auto-refreshed,
about every 30 seconds. You
can also manually click Refresh
to view the updated
information.
VPI/VCI
Most information on the
“WAN Connection” page are
read-only except the VPI/VCI
value. To revise the values,
click the value link under the
VPI/VCI column. This will
open the “Modify ATM PVC”
page, which is linked to the
“WAN Configuration
(WAN)” page in Advanced
Setup. (see Figure 4-7) You
can modify ATM Properties
and IP Configuration for
your DSL connection.
However, unless instructed by your DSL service provider, you should not change the
values. Changing the VPI/VCI values without first consulting your DSL service
provider will cause your DSL connection being interrupted.
Figure 4-6
Figure 4-7