User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
User Manual
BritePort 8120
27
6. At this time, Windows may prompt
you to reboot your computer to
make the changes taken effect
(Figure 3-5). Click Yes to proceed.
Your system is now ready to communicate with your BritePort 8120.
Configuring Windows 2000/XP for Dynamic IP Address
1. From your Windows 2000 or XP desktop, click Start -> Settings -> Network and
Dial-up Connections -> Local Area Connection, as shown in Figure 3-6.
Click Local Area Connection, and then Properties to bring out the “Local Area
Connection Properties” dialog box.
Figure 3-5
Figure 3-6