User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
24
User Manual
BritePort 8120
Before You Begin
The web-based configuration tool of BritePort 8120 can be accessed through any web
browser. Prior to access the web tool, please check to ensure the followings are ready:
• Make sure you have all the setup information ready. The setup information,
including IP address, Subnet Mask, and Gateway address, should be provided by
your DSL service provider at the time that your DSL line connection is established.
• If your DSL connection is via DHCP or PPPoE, your service provider will not
provide you with specific IP address & Subnet Mask information.
• Make sure your BritePort 8120 is properly connected to a computer through a 10/
100Mbps Ethernet port and is power on.
• Make sure your DSL service is established and the line is connected, using a RJ-11
phone cable, to the BritePort 8120 DSL port located at the back of the unit.
• Before starting the web tool, make sure the computer that connected to your
BritePort 8120 has Network Properties configured to obtain an IP address
automatically. Refer to the following section, Configuring Your Computer, for a
step by step instructions to set up your computer for DHCP, or obtain an IP address
automatically.