User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
User Manual
BritePort 8120
19
Note: If your service provider has installed a splitter, do not use the microfilters.
Important Notes:
• If you have an outlet shared by two or more devices (such as a phone and Caller ID
box), you only need to install one microfilter on this outlet.
• If you have a second phone line that is separate from the DSL line, generally, you
do not need to install microfilter on those outlets. However, if you experience noise
on the second line, you may wish to install microfilters on those outlets as well.
• For a two-line phone where one of them shares a DSL line, if you experience static
or disruption of service after installing a microfilter, you will need to purchase a
line swapper. You need to first install the swapper on the outlet, and then connect
the microfilter to the swapper.
• If you currently subscribe to an Intercom or Monitoring service through a phone
outlet, please contact your Intercom/Monitoring service provider before installing a
microfilter to the outlet. Once installation is complete, you should contact the
Intercom/Monitoring service provider again to test the line.
Figure 2-3