User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
16
User Manual
BritePort 8120
Backside view of Broadxent BritePort 8120
Located at the rear panel of your Broadxent BritePort 8120 are several connectors (see
Figure 2-1) that allow you to connect DSL line, PCs, and/or a hub to your BritePort 8120.
For details on connecting devices to BritePort 8120, refer to Figure 2-4 and Figure 2-5.
PHONE jack
Optional: Connect a telephone equipment to the PHONE jack on BritePort 8120. Be sure to
connect a microfilter in series as shown in the Figure 2-2 and Figure 2-3.
Note: This PHONE jack will work only for “splitterless” DSL line. If your service
provider has installed a splitter, do not use the microfilters.
DSL line jack
Using the RJ-11 phone cable, connect your DSL-enabled telephone line (the wall phone
outlet) to the DSL LINE jack located on the back of you BritePort 8120.
Figure 2-1: Backside view of BritePort 8120
Power Adapter
Plug
PHONE Jack
DSL line
Jack
Ethernet Ports
(Four)
RESET button
ON/OFF Switch