User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
User Manual
BritePort 8120
11
Getting Started
This section provides you important information on what to prepare prior to configuring
your DSL connection, where to locate important product registration information, the
minimum system requirements, and package contents.
Important Notes
• You must sign up with a DSL service provider.
• Make sure that your telephone line has been enabled for the DSL service.
• You must know if your service provider uses Dynamic Host Configuration Protocol
(DHCP) or Static IP address. If your service provider uses Static IP address, then you
should be provided with IP address, Subnet mask, Gateway address, and DNS address.
• For your computer connected to the Ethernet port of 8120, to set up properly for DSL
connection, the following steps are required:
(a) Install the hardware as explained in Chapter 2: Hardware Installation.
(b) Configure the computer’s Networking Properties as explained in the
beginning of Chapter 3: BritePort Setup Wizard.
(c) Configure your BritePort as explained in the Chapter 3: BritePort
Setup Wizard.
(d) Start using your DSL line.
• If you face any problem or for any clarification, you should go through Appendixes on
Troubleshooting and Frequently Asked Questions.
Model and Serial Numbers
Your BritePort 8120 has model and serial numbers. You may locate them on the bottom of
the unit. Note down the model and serial numbers for future reference.