User manual

User Manual
BritePort 8012-V1
38
4. The DSL LED on BritePort keeps blinking
Cause Your BritePort 8012-V1 is not properly configured/setup or your DSL service is down.
Solution Try the following solutions:
❑ Make sure that your telephone line has been activated for the DSL service.
❑ Check your telephone line for the dial-tone. If your telephone line is down, you will not
have DSL service. Contact your telephone company.
❑ Be sure that the telephone cable is connected correctly to your BritePort.
❑ Try connecting again after a few minutes as external interference might have caused
noise to your DSL line.
❑ Attach microfilters to all phone jacks connected to analog devices that share the same
line as your DSL connection.
❑ Be sure that you have configured your BritePort correctly. See Chapter 3: System
Configuration Tool.
❑ Check with your DSL service provider.