User manual

User Manual
BritePort 8012-G1
16
About Your BritePort 8012-G1
Located at the rear panel of your Broadxent BritePort 8012-G1(see Figure 1-1) are several
connectors that allow you to attach your computer and a telephone equipment, as shown in
Figure 1-3.
PHONE port
Optional: Connect a telephone to the PHONE jack on your Broadxent BritePort 8012-G1. Be
sure to connect a microfilter in series as shown in the Figure 1-2.
DSL LINE port
Using the RJ-11 phone cable, connect your DSL-enabled telephone line (the wall phone outlet)
to the DSL LINE jack located on your Broadxent BritePort 8012-G1.
Note: This PHONE jack will work only for “splitterless” DSL line. If your service provider
has installed a splitter, then do not use the microfilters.
Ethernet port
Using the RJ-45 Ethernet cable, the Ethernet port connects your Broadxent BritePort 8012-G1
to the Ethernet Network Interface Card in a PC. You can also use the Ethernet port on BritePort
8012-G1 to connect multiple computers through a hub. Then, you must use a proper Ethernet
cable (crossed or straight) depending upon the type of port on the hub.
Figure 1-1: Rear panel of BritePort 8012-G1