User manual

LinkMAX

 HSA300A User Manual
Page 37 of 49
Copyright ©2003 BroadMax Technology Limited
The NAT Inbound can only be used when a routed protocol is configured and
NAT is enabled. The setup page appears as follows:
The following information is required to setup a NAT Inbound entry:
• IP
The IP address on the private network which the packet's destination
IP address should be translated to.
• Port
The destination UDP/TCP port number to match in the incoming traffic.
• Protocol
The IP protocol, either UDP or TCP.
To add an inbound entry, fill in the form then click add.
To remove an entry, click delete beside the current entry table.
Click Save at the bottom of the page to validate changes.