User manual

LinkMAX



 HSA300A User Manual

Page 21 of 49

5. Web-Based Configuration

5.1 Introduction

Your HSA300A modem can be configured through a web browser. Web-

based configuration provides a user-friendly interface for users to set up their

modems for most common use.

In this chapter, we are going to guide you through the set-up procedure using

the web-based configuration.

5.2 Before clicking on the web-browser...

Please make sure the HSA300A modem and the PC are connected by an

Ethernet cable.

The default modem IP address is 192.168.0.1 with subnet mask

255.255.255.0. The IP address of the HSA300A modem and the IP address

of the PC must be in the same subnet (e.g. PC’s IP: 192.168.0.2 with subnet

mask 255.255.255.0). If the IP address of the PC and the HSA300A modem

are not in the same subnet, users should modify IP address of the PC in

Microsoft Windows.

The following section will describe the modification method in detail.

5.2.1 Modify IP address in Windows XP / 2000

This section describes the modification of IP address in Windows XP or 2000.

Before this procedure is followed, the modem should be powered on and

connected to the PC Ethernet port.

To change the IP address on Windows XP / 2000:

1.) Open the Network and Dial-up Connections Window -- From your

Windows taskbar, click Start -> (Settings ->) Control Panel -> Network

(and Dial-up) Connections