User manual

LinkMAX



 HSA300 User Manual

4. From the IPF Type drop-down list, select the level of IP

Firewall to be used on this interface, as defined above.

5. In the Lower Interface field, select the lower-level interface

name over which this protocol is being configured. Typically,

an EOA interface is configured to operate over an aal5

interface, such as aal5-0.

If you are using HSA300 as a bridge only, skip to step 7.

6. If you are using HSA300 as a router on your LAN, enter the

IP address and network mask you want to assign to the

interface. This address serves as the public IP address for

your entire LAN and is usually assigned by your ISP.

Or, if your ISP will assign this information, click the Enable radio

button to set up the DHCP service.

Also, specify whether this interface should serve as the default

route for your LAN for accessing the Internet.

7. Click

A confirmation page display to confirm your changes.

Click to return to the EOA page and view the new

interface in the table.

9. Click the Admin tab, and then click

Commit & Reboot

in the

task bar.

10. Click

to save your changes to permanent

memory.