User manual

LinkMAX



 HSA300 User Manual

Quick Start

This Quick Start provides basic instructions for connecting HSA300

to a computer or LAN and to the Internet.

! Part 1 describes setting up the hardware.

! Part 2 describes how to configure Internet properties on

your computer(s) and how to install the software for using a

computer attached to the USB port.

Part 3 shows you how to configure basic settings on

HSA300 to get your LAN connected to the Internet.

This Quick Start assumes that you have already established ADSL

service with your Internet service provider (ISP). These instructions

provide a basic configuration that should be compatible with your

home or small office network setup. Refer to the subsequent

chapters for additional configuration instructions.

Part 1 — Connecting the Hardware

In Part 1, you connect the device to the phone jack, the power

outlet, and your computer or network.

WARNING

Before you begin, turn the power off for all devices. These

include your computer(s), your LAN hub/switch (if applicable),

and HSA300.

Step 1. Connect the ADSL cable and optional telephone.

Connect one end of the provided phone cable to the port labeled

LINE on the rear panel of the device. Connect the other end to your

wall phone jack.