Instruction manual

Model 14 pH/Redox Transmitter
Chapter 2:
Installation of the Instrument
2-1
2.1 Unpacking the Instrument
The analyzer should be unpacked with great care.
Watch for any loose accessories. Confirm the instru-
ment includes: instruction manual, certificate of con-
formity, 4 cable glands, 2 fittings and 2 mounting
screws.
The analyzer has been factory-checked and tested prior
to shipment. It is advisable, however, to inspect all
parts immediately upon receipt for any damage which
may have occurred during shipment. A damaged ship-
ping container may indicate internal damage, which
may not be immediately obvious. If there is any evi-
dence of damage, keep the shipping container and
refer to your local agent or to:
Broadley Technologies Corporation
19 Thomas
Irvine, CA 92618 USA
877-246-7900
2.2 Installation Requirements
The analyzer should be located in a site, which permits
access for inspection or maintenance operations.
Choose a site which meets the following criteria:
-No excessive vibrations
-Away from direct sunlight or other outdoor
exposure
-Ambient temperature and humidity are within
specifications
Note: It is preferable to mount the instrument above
eye level, allowing unrestricted view of the front panel
displays and controls.
2.3 Mounting Options (using the red clamping
bow)
The transmitter housing conforms to norm DIN 43700.
CAUTION!
Mounting should be done by qualified
service personnel only. No power should
be applied until the installation is com-
plete.