Specifications

Product Description

IP Office Release 7.0

Page 91

Issue 22.a.- (21 March 2011)

IP500 Trunk Cards

IP500 trunk cards can be fitted to existing IP500 base cards to provide support for trunk ports. The trunk card

uses the ports provided on the base card for cable connection. The addition of an IP500 trunk card is

supported on IP500 Digital Station, IP500 Analog Phone and IP500 VCM base cards. They are not supported on

the IP500 Legacy Card Carrier base card.

For those base cards that support trunk cards, there are no restrictions on the combination of card types.

However in systems with both Analog Phone 8 base cards and analog trunk cards, combining the two types are

recommended as it then provides analog power failure support for one trunk/extension (Not applicable to the

Analog Phone 2 base card).

Each trunk card is supplied with the spacer pegs required for installation and a label to identify the card's

presence on the physical unit once installed.

· IP500 Analog Trunk Card (Maximum 4).

· IP500 BRI Trunk Card (Maximum 4).

· IP500 Universal PRI Trunk Card (Maximum 4).

IP500 Analog Trunk Card

This card can be added to an IP500 Digital Station card, IP500 Analog Phone base card, or IP500 VCM card. It

allows that card to then also support 4 analog loop-start trunks. Only one analog V.32 modem is supported on

a system.

· When fitted to an IP500 Analog Phone 8 base card (not Phone 2), the combination supports 1 power

failure extension to trunk connection.