Datasheet

2
Device Selection Guide

d
Typ. I
V
Package Viewing Package
Part Number (nm) (mcd) Description Angle 2
1
/
2
Outline
HLMA-QL00 590 500 Domed, 15° B
HLMT-QL00 590 1000 Nondi used,
HLMA-QJ00 605 500 Untinted
HLMA-QH00 615 500
HLMT-QH00 615 800
HLMA-QG00 626 500
HLMT-QG00 622 1000
HLMA-QF00 635 500
HLMA-PL00 590 75 Flat Top, 125° A
HLMT-PL00 590 150 Nondi used,
HLMA-PJ00 605 75 Untinted
HLMA-PH00 615 75
HLMT-PH00 615 120
HLMA-PG00 626 75
HLMT-PG00 622 150
HLMA-PF00 635 75
Absolute Maximum Ratings at T
A
= 25°C
Parameter HLMA-xxxx HLMT-xxxx Unit
Peak Forward Current
[2]
100 100 mA
Average Forward Current (I
PEAK
= 100 mA)
[1,2]
30 30 mA
DC Forward Current
[3,5,6]
50 50 mA
Power Dissipation 120 130 mW
Reverse Voltage (I
R
= 100 μA) 5 V
Transient Forward Current (10 μs Pulse)
[5]
500 mA
Operating Temperature Range –40 to +100 °C
Storage Temperature Range –55 to +100 °C
LED Junction Temperature 110 °C
Lead Soldering Temperature [1.6 mm (0.063 in.) from body] 260°C for 5 seconds
SMT Re ow Soldering Temperature 260°C for 20 seconds
Notes:
1. Maximum I
AVG
at f = 1 kHz.
2. Refer to Figure 5 to establish pulsed operating conditions.
3. Derate linearly as shown in Figure 4.
4. The transient peak current is the maximum non-recurring peak current these devices can withstand without damaging the LED die and wire
bonds. Operation at currents above Absolute Maximum Peak Forward Current is not recommended.
5. Drive currents between 10 mA and 30 mA are recommended for best long term performance.
6. Operation at currents below 5 mA is not recommended, please contact your Avago sales representative.