Datasheet

Recommended Assembly Condition
• A single-sided phenolic printed circuit board (PCB) is
preferred. Double-sided PCB and other materials may
cause greater lead stress. Recommended through-
hole diameter is 0.98 to 1.08 mm. Leadlength below
the PCB should be 1.5 to 2.0 mm, and the clinching
angle (angle between the lead and PCB) should be 30
±10 degrees.
• If SMT devices and an adhesive are used on the same
pcb as these lamps, the adhesive should be cured
before the lamps are auto-inserted. If curing must
be done after lamp insertion, the cure
temperature and time should not exceed 140°C,
100 seconds. This is the temperature of the surface
normal to the IR source.
TAPE & REEL (for option #002 only)
AMMO PACK (for All options except #002)
Package Options
Lead Option Ammo Pack Tape & Reel
(1000 pcs.) (2000 pcs.)
Straight Lead #2C — #002
Formed Lead #2U — –
REELING ORIENTATION
CLOCKWISE
ADHESIVE TAPE MUST BE
FACING TOWARDS THE
OUTSIDE OF THE REEL.
ANODE LEAD LEAVES
THE REEL FIRST.
PROTECTIVE
CARDBOARD
110 (4.33) DIA.
336 (13.23) DIA.
DIMENSIONS IN MILLIMETERS (INCHES).