Datasheet

4
DH AS High High
Standard AlGaAs Eff. Perf. Emerald
Parameter Red Red Red Orange Yellow Green Green Units
DC Forward Current
[1]
50 30 30 30 20 30 30 mA
Peak Forward Current
[2]
1000 300 90 90 60 90 90 mA
DC Forward Voltage 6 6 6 6 V
(Resistor Lamps Only)
Reverse Voltage (I
R
= 100 µA)5 555555V
Transient Forward Current
[3]
2000 500 500 500 500 500 500 mA
(10 µs Pulse)
Operating Temperature Range: -55 to -40 to -55 to +100 -40 to -20 to
Non-Resistor Lamps +100 +100 +100 +100
°C
Resistor Lamps -40 to +85 -20 to
+85
Storage Temperature Range °C
For Thru Hole Devices 260°C for 5 Seconds
Wave Soldering Temperature
[1.6 mm (0.063 in.) from body]
For Surface Mount Devices:
Convective IR 235°C for 90 Seconds
Vapor Phase 215°C for 3 Minutes
Absolute Maximum Ratings at T
A
= 25°C
-55 to +100
Notes:
1. See Figure 5 for current derating vs. ambient temperature. Derating is not applicable to resistor lamps.
2. Refer to Figure 6 showing Max. Tolerable Peak Current vs. Pulse Duration to establish pulsed operating conditions.
3. The transient peak current is the maximum non-recurring peak current the device can withstand without failure. Do not
operate these lamps at this high current.