Datasheet

9
Set Screw Style Encoder
1. If not using optional alignment pins or motor boss to
locate the base plate, slip alignment tool onto motor
shaft. Slip encoder base plate into place on motor
as shown below. Tighten screws or attach with an
adhesive. If using alignment tool, remove it.
ALIGNMENT TOOL
BASE PLATE
MOTOR
2. Slip the set screw hub into the shaft. Proper  nger-wear must be worn to avoid contamination on codewheel surface
(top of hub). Place an Allen wrench into the socket of the set screw while aligning it on the Allen wrench groove.
Lining up the guide (connector side) at the bottom of the housing with the slot (indicator side) on the encoder
baseplate, the housing latches should be aligned to the respective baseplate catches. Move the housing assembly
downward until the 3 latches make contact with the catches.
HOUSING ASSEMBLY
GUIDE
(CONNECTOR
SIDE)
SLOT
(INDICATOR SIDE)
MOTOR SHAFT
SET SCREW HUB
ALLEN
WRENCH
ALLEN WRENCH GROOVE