Datasheet

8
4. Using the end of a pen or other appropriate tool,
press the triangular portion of the housing assembly
downward. Recommended force is between 3.5 kgf
to 4.0 kgf. This will set the codewheel and hub into
their proper position through the internalguide of the
triangular piece. When the triangular piece is released,
it should naturally spring back to its original position,
eliminating contact between the housing assembly
and the codewheel. The encoder is now ready for use.
3. Press down the housing assembly until it snaps into
place. Recommended force is 3.5 kgf minimum, 4.0 kgf
nominal, and 4.5 kgf maximum. Note that the encoder
is shipped such that the housing assembly and the
base plate are not being snapped together.