Datasheet

7
Encoder Mounting and Assembly
Press Fit Style Encoder
1. If not using optional alignment pins or motor boss to
locate the base plate, slip alignment tool onto motor
shaft. Slip encoder base plate into place on motor
as shown below. Tighten screws or attach with an
adhesive. If using alignment tool, remove it.
ALIGNMENT TOOL
BASE PLATE
MOTOR
2. Place the hub in the housing assembly on top of the
motor shaft. Lining up the guide (connector side) at
the bottom of the housing with the slot (indicator side)
on the encoder base plate, the housing latches should
be aligned to the respective baseplate catches now.
Press the housing assembly downward and slide the
hub into and along the shaft, until the 3 latches make
contact with the catches.
MOTOR SHAFT
LATCH
(3 POSITION)
CATCH
(3 POSITION)
INDICATOR
SLOT (INDICATOR SIDE)
INDICATOR
60.0°
NOTE:
THIS IS A TOP VIEW OF THE BASE PLATE.
INDICATOR IS ALSO INDICATING THE
CONNECTOR DIRECTION. ANGULAR OFFSET
TO OPTIONAL ALIGNMENT PIN IS 60°.
TOLERANCE FOR THE ANGLE IS ± 2°.
GUIDE
(CONNECTOR SIDE)
30.0°