Datasheet

12
Package Characteristics
All specications are at T
A
=+25°C.
Parameter Symbol Min. Typ. Max. Units Test Conditions
Input-Output Momentary SO8 V
ISO
2500 V
RMS
RH≤ 50%, t = 1 min
Withstand Voltage
[9]
SO16 V
ISO
2500 RH≤50%, t = 1 min
Input-Output Insulation
[10] [11]
SO8 I
I-O
5 µA 45% RH, t=5 sec, V
I-O
=3kV DC
SO16 I
I-O
5 45% RH, t=5 sec, V
I-O
=3kV DC
Input-Output Resistance
[10]
SO8 R
I-O
10
9
10
11
Ω V
I-O
= 500V DC
SO16 R
I-O
10
9
10
11
V
I-O
= 500V DC
Input-Output Capacitance
[10]
SO8 C
I-O
0.7 pF f = 1 MHz
SO16 C
I-O
0.7 f = 1 MHz
Input-Input Insulation SO8 I
I-I
0.005 µA RH ≤45%, t=5 sec, V
I-I
=500V
Leakage Current
[12]
SO16 I
I-I
0.005 RH≤45%, t=5 sec, V
I-I
=500V
Input-Input Resistance
[12]
SO8 R
I-I
10
11
Ω RH≤45%, t= 5 sec, V
I-I
=500V
SO16 R
I-I
10
11
RH≤45%, t=5 sec, V
I-I
=500V
Input-Input Capacitance
[12]
SO8 C
I-I
0.1 pF f = 1 MHz
SO16 C
I-I
0.12 f = 1 MHz
Electrostatic Discharge Sensitivity
This product has been tested for electrostatic sensitivity
to the limits stated in the specications. However, Avago
recommends that all integrated circuits be handled with
appropriate care to avoid damage. Damage caused by
inappropriate handling or storage could range from per-
formance degradation to complete failure.
Notes:
9. V
ISO
is a dielectric voltage rating that should not be interpreted as an input-output continuous voltage rating. For continuous voltage rating,
refer to the IEC/EN/DIN EN 60747-5-2 Insulation Characteristics Table (if applicable), the equipment level safety specication or Avago Applica-
tion Note 1074 entitled “Optocoupler Input-Output Endurance Voltage.”
10. Measured between each input pair shorted together and all output connections for that channel shorted together.
11. In accordance to UL1577, each optocoupler is proof tested by applying an insulation test voltage ≥ 3000 Vrms for 1 sec (leakage detection
current limit, I
I-O
≤ 5 µA). This test is performed before the 100% production test for partial discharge (Method b) shown in the IEC/EN/DIN EN
60747-5-2 Insulation Characteristics Table, if applicable.
12. Measured between inputs with the LED anode and cathode shorted together.