Specifications

e-mail:
[e-mail]
voice:
360.854.9559
fax:
866.783.1742
7
SS 16.2 Installation and Operation Manual
INSTALLATION
INSTALLATION Continued
The 16x2 is a passive switcher. Any one of the 16 inputs may be assigned to either
or both outputs, but inputs can never be mixed.
1 To assign an input to output 1, press any one of the 16 input switches.
The associated LED will light.
2 To assign an input to output 2, press and hold the “OP 2” switch, then press
the desired input switch. The associated LED will flash slowly.
3 To select an input to both outputs, press the desired input switch, then press
and hold the “OP 2” switch followed by pressing the same input switch
once again. The associated LED will flash rapidly.
4 To mute any input routed to output 1, press the MUTE switch. NOTE: If
both outputs are muted, the mute LED will flash.
5 To mute any input routed to output 2, press and hold the MUTE switch;
then press the “OP 2” switch. NOTE: If both outputs are muted, the mute
LED will flash.
6 To mute both outputs, press the MUTE switch, then press and hold the
“OP 2” switch, and then press the MUTE switch. The mute LED will flash.
The Power Led is designed to light when power is valid. Its second job is to indi-
cate when serial data is sent or received. The third is to flash when the 16x2 is in
the “Programming” mode.
Serial Control
12 = Set PIP Mode: stretch positive pulses to minimum 1 second
13 = Set PIP Mode: stretch positive pulses to minimum of 2 seconds
14 = Set PIP Mode: stretch positive pulses to minimum of 4 second
15 = OFF = Allows selection of power up channel. Select after out of
programming mode. Default
ON = Selects “Last Source Selected”
16 = OFF (initial state) – switches 1-15 behave as above
Power LED Blinking – (final state) – input switches behave as if 3 were
off, but are recorded.
Pin out of the modular/D-Sub adapter is shown below.
RJ-11 Adapter.
Pin Number.
DB-9 Female. Pin
Number.
Product’s point of
view Function
Name.
4 3 RS-232 Receive
3 2 RS-232 Transmit
2 5 Ground