Specifications
e-mail:
support@broadcasttools.com
voice:
360.854.9559
fax:
866.783.1742
6
SS 16.2 Installation and Operation Manual
INSTALLATION
INSTALLATION Continued
STEP 3: BENCH TEST and OPTIONS
Place each unit on a workspace and connect power to the unit. Check to see if LED
#1 (Switch 1) and the Pwr/Ser LED are lit (Source one is the power-up factory
default). Connect an audio source to stereo input one and a monitoring device to the
output(s). Verify that audio is present at both outputs. Repeat the process until each
channel’s operation has been verified.
OPTIONS
JP2 To enable the front panel “ENABLE” switch, place a jumper over JP2. The
Enable switch is disabled at the factory.
DIP Switches
3 OFF = Normal operations (Default)
3 ON = Front Panel programming. Use the front panel switches and LED’s.
4 = Not used
Pressing a button selects the option and stores it. The LED shows the state of the
option. When finished, initial channel settings can be selected by pressing button 16,
at which point the channel 16 LED stops flashing. Then using the front panel like
normal will have the same effects as normal, but will record those settings as the
startup settings. To exit this mode, turn off the unit, turn off Switch 3, then turn the
unit back on.
!
TIP
The “ACT” LED’s are
also an audio output
indicator.
NOTE:
When the unit is in
“Programming” mode,
the “Channel 16” and
“Power” LED’s flash
rapidly. The current
settings are displayed
on their respective
LED’s.
WEBSITE:
Visit our web site for
product updates and
additional information
DIP (SW-2) Switch Functions
Unit ID SW2-1 SW2-2
ID 0 * OFF OFF
ID 1 ON OFF
ID 2 OFF ON
ID 3 ON ON
1 = 1200 Baud
2 = 2400 Baud
3 = 4800 Baud
4 = 9600 Baud Default
5 = 19200 Baud
6 = 38400 Baud
7 = OFF = Open collectors follow inputs (Latch) Default
ON = Open collector pulse for 1 sec
8 = OFF = Open collectors follow switch 7 rules Default
ON = Open collectors are software controlled.
9 = Set external inputs to act like front panel switches
10 = Set PIP Mode: Follow Inputs
11 = Set PIP Mode: stretch positive pulses to minimum 1/2 second