Specifications

e-mail:
[e-mail]
voice:
360.854.9559
fax:
866.783.1742
4
SS 16.2 Installation and Operation Manual
DESCRIPTION
FRONT PANEL DESCRIPTION
SOURCE SWITCHES
Each switch represents an input to be routed to either or both of the outputs. High
quality tactile switches will give the user years of dependable service. Each switch
has an associated LED indicator, which will illuminate when that particular source
is routed to either or both of the outputs. When a source is selected, the previous
source will be deselected, (interlocked). The ENABLE switch, when enabled, must
be pressed and held in order for any of the source switches to function. This func-
tion may be bypassed. The front panel is also equipped with a MUTE switch. This
switch, when pressed in combination with the OP 2 and/or ENABLE switch, turns
off the output.
LEDS
LED indicators, which will illuminate when the desired channel is selected to out-
put one, slowly flash when to only output two and rapidly flash when to assigned to
both outputs. The Pwr/Ser LED displays valid power and serial data activity. The
mute LED denotes when audio is off. The respective activity LED’s light when
audio is present at the appropriate output.
REAR PANEL DESCRIPTION
The rear panel contains all input, output and remote control interfacing connectors.
Audio inputs and outputs are routed through pluggable screw terminals. Remote
control is accomplished via a 37 pin “D” connector. A modular jack is provided for
the multi-drop serial port.
POWER
Connect the 2.1mm coaxial type power connector into the unit and the 9 VAC
@ 500 ma wall transformer into a 120 Vac 50-60 Hz power source. The front panel
power LED indicates when power is applied to the unit. (220 Vac 50-60 Hz wall
transformer OPTIONAL)
AUDIO SIGNAL CONNECTOR
The 16 x 2 is supplied with Pluggable Screw terminals (Euro) and Mating connec-
tors. Channel and polarity designators can be found on the left side of the printed cir-
cuit board, as viewed from the rear.
“REMOTE” J3, CONNECTOR
The male 37 pin “D” connector is provided for connection to equipment, which will
remotely control the 16 x 2. Momentary contact closure to ground or active low
logic will satisfy all input functions.