Operator`s manual

ES-2200 System Configuration

This section shows how to set cards and install them to be operated from the front panel of the ES-2200 unit.

Remember:

All DIP Switches must be configured with the power off.

Static electricity from your body can damage the cards. To prevent this type of damage, you should handle them

carefully:

• Do not take them out of their conductive bags until you are ready to install them.

• Do not carry them around the room unless they are in their conductive bags.

• Before touching them, discharge any static electricity from your body by first touching the grounded metal chassis.

Figure 1-2: ES-2200 Front Panel DIP Switch Assignments

TX GND RX

Remote Connector

TX GND RX

Unit 2 Connector

TX GND RX

Unit 1 Connector

1 2 3 4 5 6 7 8

Up Position

Down Position