Operator`s manual

12 hex 2 (0,0-F,F) Set Strobe Rate (in Frames)

00 = Full Motion

01 = Fastest Strobe

7F = Slowest Strobe

13 hex 1 (0-2) Select Freeze Mode

0 = Frame Mode

1 = Field Mode

2 = Strobe Mode

(Valid for MicroSYNC cards only) 3= 4-Field Mode

(Valid for TBC IV cards only) 4= Film Mode

14 hex 1 (0-2) Freeze Field Select

0 = Select Field 1

1 = Select Field 2

2 = Select Field 3

3 = Select Field 4 ...MicroSYNC only

4 = Select Field 5 ...MicroSYNC only

16hex 1 (0-F) Y/C Delay horizontal

0 = +570nS

8 = 0

F = -490nS

24hex 1 (0-3) Y/C Delay vertical

0 = +1 line

1 = 0

2 = -1 line

3 = -2 lines

25 hex 1 (0-1) Set Monochrome Mode

0 = Monochrome Mode Off

1 = Monochrome Mode On (Chroma OFF)

32 hex 2 (0,0-F,F) Set MicroSYNC Options BYTE #1

See Section below for MicroSYNC Configuration

33 hex 2 (0,0-F,F) Set MicroSYNC Options BYTE #2

See Section below for MicroSYNC Configuration

34 hex 1 (0-1) Set Frame freeze

0 = Select Frame 1

(Command valid for MicroSYNC only) 1 = Select Frame 2

35 hex 2 (0,0-F,F) Set TBC IV Configuration BYTE #1

See Section below for TBC IV Configuration.

36 hex 2 (0,0-F,F) Set TBC IV Configuration BYTE #2

See Section below for TBC IV Configuration.