Operator`s manual

GENLOCK OK LED

This LED will light when a valid genlock video signal is connected to the MicroSYNC genlock video input.

REFERENCE VIDEO INPUT

These two BNC connectors provide a loop-through (bridging) connection for the genlock reference input. Composite

color black or another stable composite video signal such as color bars should be used as a genlock reference. The

signal loop should always be terminated in 75O. If the MicroSYNC card represents the end of the reference loop, a

precision 75O BNC terminating plug should be installed on the unused jack.

When stand-alone operation is desired, the MicroSYNCs genlock external/internal option should be set to internal. This

option can be set via software or from the front panel of an ES-2200 series expansion chassis.

GENLOCK TIMING ADJUSTMENT

The rear panel genlock timing adjustment can only be used when the MicroSYNC remote control capability is disabled

(DIP Switch 8 DOWN). Do not adjust this switch if you are operating the MicroSYNC by the RC-2000 control panel.

8 7 6 5 4 3 2 1

INTERNAL SERIAL DATA

CONNECTORS

DHE 4

MUTE

TRANSMIT

BSW1

DIP Switches

DHE5

8 7 6 5 4 3 2 1

CHE2

BNC

BUS

MicroSYNC

BNC Input

CHE3

P1-B5

MicroSYNC

BUS Input

-----------P1-B12

-----------P1-B14

-----------P1-B16

-----------P1-B18

-----------P1-B20

-----------P1-B22

-----------P1-B24

-----------P1-B26

MicroSYNC Video

BUS Output

Serial Data

Transmit Control

Note:

Do not install jumper CHE3 unless is being fed by a single

RS-2800 Routing Switcher.

Figure 4-6: DPS 8-Bit MicroSYNC Card