Operator`s manual

Figure 3-2: ES-2200S Controls

Unit Select

The UNIT select button is used to address the selected installed card. Whenever UNIT 1 is selected, all of the front

panel controls and indicators display the current parameters of the card installed in the UNIT 1 slot. When UNIT 2 is

selected the front panel controls and indicators display the current parameters of the card that is installed in the UNIT 2

slot. This button is also used to select remote/local operation.

UNIT 1

When this button is selected, the ES-2200S recalls and displays the current status of the card that is connected in the

UNIT 1 slot. A flashing UNIT 1 LED indicates that the installed card is not responding to the ES-2200S commands. If

this happens, make sure that the baud rate of both the front panel and the installed card are the same and that the serial

interface cable is connected. Note that this LED will not flash if the installed unit is a V-Scope or a Personal Routing

Switcher card.

UNIT 2

When this button is selected, the ES-2200S recalls and displays the current status of the card that is connected in the

UNIT 2 slot. A flashing UNIT 2 LED indicates that the installed card is not responding to the ES-2200S commands. If

this happens, make sure that the Baud rate of both the front panel and the installed card are the same and that the serial

interface cable is connected. Note that this LED will not flash if the installed unit is a V-Scope or a Personal Routing

Switcher card.

REMOTE

The remote function causes the ES-2200S to go into REMOTE mode. The installed Personal series cards and the

MicroSYNC can now accept commands from a remote source such as a computer or a remote control module. The

commands are accepted via the rear panel's DB-9 female connector, and are processed by the front panel then passed on

to the selected unit. Holding in the SELECT button for approximately one second activates this function. When this

function is active, the front panel UNIT 1 and UNIT 2 LEDs both light up. To select local mode simply press the UNIT

1/UNIT 2 button once.

SELECT TIMING FREEZE FUNCTION PROC AMP

UNIT UNIT H-POS C F FRM/FLD TAKE BYPASS PROCESS VIDEO BLACK CHROMA HUE

1 2 FLAT LOW 1H 2H PK/VAR FREEZE NRM SUPER WAVFRM VECTOR OVERLAY SPLIT

REMOTE CONFIGURE STROBE STORE RECALL PREVIOUS UNITY

VRT BLKG MONO GEN MD BURST BLK OUT SYNC MD CLAMP IN LOCK BLK CLP HOT SW

5 MAX

4 +

3 UNITY

2 -

1 MIN

Shaft Encoder