Operator`s manual

Chapter 3:

ES-2200S Operation

Figure 3-1: ES-2200S Front Panel

This section describes the front panel controls and indicators for the ES-2200S dual channel expansion system. The ES-

2200S is designed to operate any two DPS PC cards, including the DPS MicroSYNC, Personal V-Scope, and Personal

Routing Switcher.

The SELECT button is used to address the individual cards installed in the UNIT 1 and UNIT 2 positions. After

selecting a desired unit, the front panel indicators will display the selected card parameters. The momentary push

button switches on the ES-2200S front panel are used to select the various operating modes. Pressing the appropriate

button (e.g., Video) and then rotating the shaft encoder knob performs changes to a mode setting (e.g., Video Level).

The bar graph display, located to the left of the shaft encoder, provides a relative measure of the selected setting.

The labels in red located directly above the ES-2200 front panel buttons represent V-Scope functions. The labels in

black located above the V-Scope labels represent the MicroSYNC functions. The labels in blue located at the bottom of

the front panel represent special MicroSYNC functions. The actual operation of the controls depends on the

combination of cards installed in the ES-2200S chassis. For example, if a MicroSYNC was installed in UNIT 1 and a

V-Scope in UNIT 2, the upper labels in black would refer to UNIT 1 (MicroSYNC) functions and the red labels below

them would refer to UNIT 2 (V-Scope) functions.

Certain front panel controls can perform additional functions when they are held for more than one second. These

controls are designated by italic legends printed below the respective controls. All proc amp LEDs flash when one of

the Proc Amp shift functions is initiated.

SELECT TIMING FREEZE FUNCTION PROC AMP

UNIT UNIT H-POS C F FRM/FLD TAKE BYPASS PROCESS VIDEO BLACK CHROMA HUE

1 2 FLAT LOW 1H 2H PK/VAR FREEZE NRM SUPER WAVFRM VECTOR OVERLAY SPLIT

REMOTE CONFIGURE STROBE STORE RECALL PREVIOUS UNITY

VRT BLKG MONO GEN MD BURST BLK OUT SYNC MD CLAMP IN LOCK BLK CLP HOT SW

5 MAX

4 +

3 UNITY

2 -

1 MIN

ES-2200S

DUAL MicroSYNC

EXPANSION SYSTEM

V-SCOPE CONTROLS

MicroSYNC CONFIGURATION

POWER