Operator`s manual

22
RS-2800 Personal Routing Switcher
Routing Switcher commands are not on the ES-2200T front panel. A stick-on label is provided with each switcher card.
This label should be applied to the front panel underneath the proc-amp controls.
The ES-2200T can be configured to control one or two switcher cards. The Routing Switcher card has a four by one
(4x1) switching matrix accessible through the four input BNC connectors at the rear of the card. The Routing switcher
card also has an eight by one (8x1) switching matrix accessible through the Edge connector. When the Personal
Routing Switcher card is used in the ES-2200T, the 8x1 matrix can't be accessed and therefore is not used. The front
panel can control the 4x1 matrix as indicated on the label.
IN-1
When selected, the Personal Routing Switcher routes the video source on input #1 to the output BNC.
IN-2
When selected, the Personal Routing Switcher routes the video source on input #2 to the output BNC.
IN-3
When selected, the Personal Routing Switcher routes the video source on input #3 to the output BNC.
IN-4
When selected, the Personal Routing Switcher routes the video source on input #4 to the output BNC.
PROC AMP
IN-1 IN-2 IN-3 IN-4
STORE RECALL PREVIOUS UNITY
CMB FLTR HOT SW
Place Sticker Here