Operator`s manual

TBC Configuration Functions

Button Function/ Mode

VRT BLKG Vertical Blanking Width

1. Narrow

2. Wide

MONO Monochrome Mode

1. Normal

2. Forced Monochrome

GEN MD Genlock Adjust

1.Genlock Adjust Enable

2. Genlock Adjust Disable

BURST Output Burst Mode

1. On

2. Off

BLK OUT TBC Function

1. Normal

2. Super Black Out

GEN TERM Genlock Termination

1. High Impedance

2. 75O terminated

CMB FLTR TBC IV Chroma Filter/Option Card Comb Filter

1. TBC IV Chroma On/Comb Filter Off

2. TBC IV Chroma Off/Comb Filter Off

3. TBC IV Chroma Off/Comb Filter On

HOT SW Hot Switch Mode

1. Disable

2. Enable

Note: Mode 1 is the default factory setting for all functions.

TBC IV Option Card Controls

If your TBC IV is not equipped with an option card then skip this section. If the TBC IV is equipped with an option

card, Betacam and MII outputs will be added to the TBC IVs Mini DIN-9 connector. Luminance and chrominance

noise reduction will also be available. To operate the TBC IV option card functions, follow the procedure outlined

under TBC CONFIGURATION earlier in this chapter. (Refer to the TBC IV/Option card manual for more

information.)