Operator`s manual

11
ES-2200S Configuration options
The ES-2200S chassis is designed to accept DPS 8-bit MicroSYNC cards and 10-bit MicroSYNC-X cards, as well as
Personal V-Scopes, VDAs and Routing Switchers. The possible combinations are:
Unit 1 Unit 2
VS-2400
VS-2410
VS-2400 VS-2400
VS-2410 VS-2410
VS-2400 V-Scope
VS-2410 V-Scope
VS-2400 Routing Switcher
VS-2410 Routing Switcher
VS-2400 VDA
VS-2410 VDA
ES-2200S Card Installation
1. Before installation, remove the carrier plates from the backs of the cards and save the screws to mount the cards in
the chassis.
2. With the power off, remove the top cover of the chassis.
3. Place DIP Switch 2 on the card intended for unit 1 in the down position and all others up.
4. If a Personal V-Scope is intended for the unit 2 position, place the DIP Switch on the V-Scope 1 in the down
position, and all others up. If any other type of card is intended for the unit 2 positon, place DIP Switches 2, 3, 4,
5, 6 and 7on the intended card in the down position and all others up.
5. On the ES-2200 front panel, place DIP Switches 1, 2, 3, 4, 5 and 6 in the up position. DIP Switches 7 and 8 are
placed in the following positions, depending on what cards you are installing:
Unit 1 Unit 2 Switch 7 Switch 8
VS-2400 DOWN DOWN
VS-2410 UP UP
VS-2400 VS-2400 DOWN DOWN
VS-2410 VS-2410 UP UP
VS-2400 V-Scope UP DOWN
VS-2410 V-Scope DOWN UP
VS-2400 Routing Switcher UP DOWN
VS-2410 Routing Switcher DOWN UP
VS-2400 VDA DOWN DOWN
VS-2410 VDA UP UP
6. Install the 3 wire RS-232 cable for unit 1 (figure 2-1) to the 3 pin header labeled INPUT at the top of the first card
near the BNC connectors near the fan.
7. Press the power supply's edge connector for unit 1 onto the first card as far as it will go.
8. Mount the first card in the unit 1 position using the five screws provided and install the supplied hardware for the
rear panel support bracket.