Specifications

e-mail: [e-mail] voice: 360.854.9559 fax: [phone]
20
WVRC-8 Installation and Operation Manual
PROGRAMMING
Recording Voice Messages
The following steps are required to record voice messages into the WVRC-8.
NOTE: If the time allotted for the message you are recording elapses before the
“PGM” button is pressed, it will turn off automatically.
Example: To record the greeting message, press the “PGM” button, enter 00 on the key-
pad, speak the new greeting message, then press the “PGM” button again.
1 - Connect a TT telephone to either the front or rear panel RJ-11 jacks labeled “PGM”.
2 - Press the front panel “PGM” button; this should illuminate the front panel “PGM” led.
3 - Enter the two-digit address of the message you wish to program. The list of messages
are below.
4 - The red “REC” led will illuminate. As soon as it lights, begin speaking the new mes-
sage into the telephones mouth piece.
5 - When finished, press the PGM button again, the “REC” and the “PGM” led’s will
extinguish.
NOTE: The following above procedures allows changing any of the messages.
If you want to listen to a message, without recording, preface the address with
the asterisk (*) key.
Example: To hear the current greeting message, press the “PGM” button and
Enter *00. The current greeting message will play. Here is a list of the voice
messages pre-recorded in the WVRC-8.