Specifications

e-mail: [e-mail] voice: 360.854.9559 fax: [phone]
17
SS 4x4 Installation and Operation Manual
OPERATION
Relay and Open Collector Commands
*uOOoF - Unlatch open collector “o” (Only works in NON-Remote mode
*uOOoL - Latch open collector “o” (Only works in NON-Remote mode
*uOOoP - Pulse open collector “o” (Only works in NON-Remote mode
Audio Switch Control Commands
*uiio - Apply input “ii” to output “o”
*uiiA - Apply input “ii” to ALL outputs
*uiiEott - Start overlap - Apply input ii to output o. After tt tenths of a second,
remove all other inputs from output o.
NOTE: Only one at a time can be pending per output. Max time 9.9 seconds
*uE - End overlap if in overlap mode. This applies to all outputs that have changed
since the last “end overlap” command was issued.
*uiiMA - Mute input “ii” for all outputs
*uiiMo - Mute input “ii” for output “o”
*uMo - Mute output “o”
*uMA - Mute all outputs
Audio Switch Control Commands
*uB,a,a,a,a Set all status ignoring mode: Lower 4 bits of A is channel #’s OR’d
together + 1, upper 4 bits is 41. NOTE: Input commands MUST be in CAPS.
A = all off
B = 1
C = 2
D = 1 + 2
E = 3
F = 3 + 1
G = 3 + 2
H = 3 + 2 + 1
I = 4 etc