Specifications

NTI VEEMUX DVI VIDEO MATRIX SWITCH
50
Buttons
The IRT-UNV Infrared Remote Control user interface consists of a keypad with 29
buttons. The buttons have the following functions:
• Numerical Values (0-9)
 Selects port numbers (for IN, OUT)
 Selects memory locations (for saved configurations)
• * (Asterisk)
 Pressed to select all outputs
• OUT
 Pressed to indicate an output port selection
• IN
 Pressed to indicate an input port selection
• IN + / -
 Cycles through input ports (up or down), connecting to each one (similar to
changing channels)
Note: This affects only the selected output port
• SAVE
 Pressed to save the current switch configuration (port connections and
volume settings)
 Up to 10 configurations can be saved (0-9)
• RECALL
 Pressed to recall a switch configuration (port connections and volume
settings)
 Up to 10 configuration can be recalled (0-9)
• SYS
 Pressed to select the desired NTI system to be controlled
 Only used when controlling multiple systems
 Must be followed by a system number: 1-15
• ENTER
 Pressed to immediately accept the command (normal delay is approx. 5
seconds).
• ESC
 Pressed to cancel the current command
Note: If the command has not yet been accepted, all button presses in the
command sequence will be cleared
• Standby
Pressed to put the unit into or out of standby mode
• VIDEO
 Pressed prior to entering a port switch command
 Applies the command to the video signals only
 (by default, port switch commands are applied to both Audio and Video)
• BL
A
NK Video
 Turns OFF Video for the selected output
 Can be used with *(Asterisk button) to turn OFF video for all outputs
 Video will be turned ON by pressing the Blank Video button again, or by switching ports
Note: Blank and Un-Blank commands are applied only to the selected output