Specifications

ee--mmaaiill::
[e-mail]
vvooiiccee::
360.854.9559
ffaaxx::
360.854.9479
7
SS 4x1 III Installation and Operation Manual
INSTALLATION
DIP (SW - 6) Switch Functions
Unit ID SW6-1 SW6-2
ID 0 * OFF OFF
ID 1 ON OFF
ID 2 OFF ON
ID 3 ON ON
Baud Rate SW6-3 SW6-4
2400 ON OFF
9600 * OFF OFF
19200 OFF ON
38400 ON ON
* = Factory setting
SW6-5 OFF = Last source selected *
ON = Power up selection
SW6-6 OFF = Normal operation *
ON = Act as a SS 2.1 switcher/Router
Input selection at power-up may be determined by holding down the desired chan-
nels push button until all LED’s flash. Factory power-up default is source # 1.
STEP 4: MOUNTING
Mount the unit in a rack or desktop, allowing adequate airflow for cooling.
STEP 5: CONNECT YOUR EQUIPMENT
The SS 4.1 III interfaces to your equipment (sources and loads) through the rear
panel pluggable screw terminals. Follow the legends for the desired audio input,
output and remote control connections, which appear on the rear side of the chassis.
Remove each screw terminal, strip each conductor, and insert the conductor into the
terminal and screw down the capture screw. The terminals accommodate wire sizes
from 16 - 28 AWG solid or stranded wire.
STEP 6: LABEL SWITCHES
Write the source descriptions under each source switch, if desired.