Specifications

e-mail: [e-mail] voice: 360.854.9559 fax: [phone]
7
SS 4.1 Plus Installation and Operation Manual
INSTALLATION
STEP 3: BENCH TEST and OPTIONS
Place each unit on a workspace and connect power to the unit. Check to see if LED
#1 (Channel 1) and the PWR LED are lit (Source one is the power-up factory
default). Connect an audio source to stereo input one and a monitoring device to the
output. Verify that audio is present. Repeat the process until each channel’s opera-
tion has been verified.
Jumper JP2
To enable the front panel “ENABLE” switch, remove and stow the jumper over
the “Enable Bypass” jumper JP2.
Note: The “Enable” switch is disabled at the factory.
Dipswitches:
DIP (SW6) Switch Functions
Unit ID SW6-1 SW6-2 SW6-3
ID 0 * OFF OFF OFF
ID 1 ON OFF OFF
ID 2 OFF ON OFF
ID 3 ON ON OFF
ID 4 OFF OFF ON
ID 5 ON OFF ON
ID 6 OFF ON ON
ID 7ONONON
Baud RateSW6-4 SW6-5
2400 ON OFF
9600 * OFF OFF
4800 OFF ON
38400 ON ON
Power Up SW6-6
User selected ON
Last source OFF
selected *
Remote/PIP SW6-7
PIP / Triggers ON
Remote Control * OFF
Note: * Denotes factory setting.
Note: After changing any dipswitch, please repower the unit.
!
TIP
The “ACT” (audio
activity) LED is an
excellent audio output
indicator.
NOTE:
Input selection at
power-up may be con-
figured by holding down
the desired channels
push button until the
mute and Pwr/Ser
LED’s flash. Factory
power-up default is
channel one.