Specifications

e-mail: [e-mail] voice: 360.854.9559 fax: [phone]
10
SS 4.1 MLR Installation and Operation Manual
OPERATION
*uSS Sends status of silence sensor: SuS,a<CR><LF>
a = 1 = not silent, 0 is silent
*uU Sends unit firmware version: <name><version><lf>
*uY Display configuration.
*uZx Echo character x to serial control port - for debugging command
strings
*uCEx Enable error and good responses if x = Y (default N)
*uCDEF Reset to factory defaults.
*uCLx Lock front panel: x = L (Lock) x = U (Unlock)
*uCIIttt Sets PIP minimum pulse length ttt: 000 - 255 => off to 2.55 seconds.
*uCPS Power up audio state: save power up state now
*uCSLx Sets silence sensor detection threshold to Off, -20, -25, -30 dB
(0,1,2,3)
*uCSAtttt Sets silence sensor acquire delay to tttt seconds (0, 2-255)
*uCSBtttt Sets silence sensor restore delay to tttt seconds (0, 2-255)
*uCSCtt Sets step interval in seconds 1-99 seconds.
*uCSSt Sets last step channel 1-4 (0 disables step feature.)
*uCSEi Sets EAS controlled input channel (i) to 1-4 or 0 for off. This allows
you to assign one input channel that will be switched to with sus-
tained closure to ground on the PIP8/EAS remote control input from
an EAS encoder for EAS audio insertion with the SS 4.1 MLR.
*uDxx Delay xx seconds before processing next command.
*uDLxxx Delay xxx seconds before processing next command.
Menu Operation
Broadcast Tools(R) SS 4.1 MLR, v1.7 - Setup Menu
1 - Set PIP Minimum Hold Time(0 - 2.55 sec) - Now:0.05
2 - Set Silence Sense Acquire Delay (sec) - Now: 10
3 - Set Silence Sense Restore Delay (sec) - Now: 2
4 - Set Silence Sense Threshold - Now:OFF
5 - Set Stepping Interval (sec 1-99) - Now: 10
6 - Set Last Step Channel - Now: 4
7 - Lock/Unlock Front Panel - Now:UNLOCKED
8 - Set EAS Controlled Input - Now: Off
S - Turn ON audio input
M - Turn OFF audio
V - Save Audio State for Power Up
C - Show Configuration and Status
F - Set Factory Defaults
Audio Status:Present - Channel 1
Enter Selection, or Q to quit:
To select a menu function, simply enter the letter on the left side of the menu and
wait for the prompt. Example: Type the letter “S” Response: Enter Input Channel:
Entering a 1 would select channel 1.
WEBSITE:
Visit our web site for
product updates and
additional information.