User manual
Table Of Contents
- User Manual
- Starlink SL9003Q
- Digital Studio Transmitter Link
- WARRANTY
- SL9003Q Manual Dwg # 602-12016-01 R: G Revision Levels:
- Using This Manual - Overview
- Section 1 System Features and Specifications
- Section 2 Quick Start
- Section 3 Installation
- Section 4 Operation
- Section 5 Module Configuration
- Section 6 Customer Service
- Section 7 System Information
- Table of Contents
- List of Figures
- List of Tables
- 1 System Features and Specifications
- 2 Quick Start
- 3 Installation
- 4 Operation
- 7.1 Introduction
- 7.2 Front Panel Operation
- 4.3 Screen Menu Navigation and Structure
- 7.4 Screen Menu Summaries
- 4.4.1 Meter
- 4.4.2 System: Card View
- 4.4.3 System: Power Supply
- 4.4.4 System: Info
- 4.4.5 System: Basic Card Setup
- 4.4.6 Factory Calibration
- 4.4.7 SYSTEM: UNIT-WIDE PARAMS
- 4.4.8 System: Date/Time
- 4.4.9 System: Transfer
- 4.4.10 System: External I/O (NMS)
- 4.4.11 Alarms/Faults
- 4.4.12 Radio: Modem Status (QAM)
- 4.4.13 Radio TX Status
- 4.4.14 Radio RX Status
- 4.4.15 Radio TX Control
- 4.4.16 Radio RX Control
- 4.4.17 Radio Modem (QAM) Configure
- 4.4.18 Radio TX Configure
- 4.4.19 Radio RX Configure
- 4.4.20 Radio Modem/TX/RX Copy Function
- 4.5 Intelligent Multiplexer PC Interface Software
- 4.6 NMS/CPU PC Interface Software
- 5 Module Configuration
- 6 Customer Service
- 7 System Description
- 8 Appendices
- Appendix A: Path Evaluation Information
- Appendix B: Audio Considerations
- Appendix C: Glossary of Terms
- Appendix D: Microvolt – dBm – Watt Conversion (50 ohms)
- Appendix E: Spectral Emission Masks
- Appendix F: Redundant Backup with TP64 and TPT-2 Transfer Panels
- Appendix G: Optimizing Radio Performance For Hostile Environments
- Appendix H: FCC APPLICATIONS INFORMATION - FCC Form 601
- Starlink SL9003Q & Digital Composite - 950 MHz Band
Appendix F: Redundant Backup F-17
Moseley SL9003Q 602-12016 Revision G
TX LOCK
INTERNAL FUSE RATING:
INPUT: 110-240V, 47-63Hz
250V
3A
DISCONNECT LINE CORD
PRIOR TO MODULE REMOVAL
AND RATING OF FUSE
REPLACE WITH SAME TYPE
FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE,
+5V
+15V
CAUTION
!!
TX AC P/S
115W
I
/O
EXT
RIGHT
CH. 2
ID#
CH. 1
LEFT
CMPR
LIN
AUDIO ENC
TRUNK
RESET
CPU
NMS
DATA
SPDIF
AES/EBU
OUT
70 MHz
MOD
TP
QAM MOD
TRUNK
RX
TX
RX
70 MHz
IN
TO PA
CONVERTER
UP/DOWN
PA IN
ANTENNA
AMP
PWR
3
21
PUSH
3
21
PUSH
3
21
PUSH
ENCODE
DATA
GND
0.25A/230V
0.5A/115V
FUSE
AUX 2
DATA 1
RESET
DATA 2
STATUS
INTERFACE
AUX 1
RIGHTLEFT
AES/EBU
OUT
ACC
3
12
PUSH
3
12
PUSH
3
12
PUSH
3
12
PUSH
3
12
PUSH
Control
Data
RS-232
Program
Source
Analog
Digital
Right
Left
AES/EBU
XLR-Tee
XLR-Tee
XLR-Tee
Radio B - MAIN Default
SL9003Q Transmitter
GNDGND
IN
PGM A
PGM B
OUT
B AC
TRANSMITTER A
GND INPUT
TRANSMITTER B
GND PROGRAM A CB GND E
REMOTE
+13F GND
POWER
PROGRAM
PROGRAM
ANTBA
Antenna
Radio A - STANDBY Default
N(m) - N(m)
RG142 36"
TPT-2 Transfer Panel (Rear)
FUSE
COMP
MONO
MUX 1
MUX 2
+ -
CHNL REMOTE
TX REMOTE
FCC ID: CSU9WKPCL6010
MOSELEY ASSOCIATES, INC.
ASSEMBLED IN USA
Operation is subject to the following two conditions.
"This device complies with Part 15 of the FCC rules.
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired
operations."
BLACK
(DGND)
GREEN
(TX_XFER_I)
RED
(TX_XFER_O)
GRAY
(DGND)
RJ45 (8-pin) to
Spade Lug (4)
(230-12225-01)
DSP-6000E & PCL6010 Transmitter
BLACK
(DGND)
GREEN
(FWD_PWR)
RED
(RAD_CNTL)
GRAY
(MODE)
QAM TX Software Settings
Radio TX Control
TX-A Radiate: AUTO
System Transfer
TX Transfer: COLD
Modem Splitter
N(m) - N(m)
RG142 36"
Figure 8-9 Starlink QAM TX with DSP/PCL TX Backup and TPT-2 Connection