Specifications

e-mail: [e-mail] voice: 360.854.9559 fax: [phone]
18
Site Sentinel
®
16 Installation and Operation Manual
SETUP
Metering
Metering input selection: Select the metering inputs 1-16 for configuration.
Meter Label: Used to identify the metering input source.
Metering Units: Label in engineering units, such as V = Volts,
A = Amps, W = Watts, etc.
Calibration: Enter the value of the desired meter reading.
NOTE: In order to calibrate, a valid DC sample voltage must be applied to
each input that you are calibrating. The calibration value must be positive and
can support a resolution up to 2 decimal places. The user MUST press the
“Save Cal” button in order to store the value. You do not need to press the
“Save Settings” button to save the calibration, only other settings.
Alarms High: This option enables the “High Trip Point” email alarm.
Alarms Low: This option enables the “Low Trip Point” email alarm.
Alarms Exit: This option enables the emailing after exiting an alarm.
Email Addresses: This allows you to configure up to 8 emails to be sent whenever
the input goes above or below a set-point.
Log Device: This enables the email logging of this device.
Delay time: The delay is in (0 to 999) seconds. This option specifies the wait
time from when a value is out of range before an alarm is activated.
Low trip point: This option specifies the LOW alarm set point.
High trip point: This option specifies the HIGH alarm set point.
NOTE: After any item has been changed, you MUST press the “Save Settings”
button for your changes to be saved.
WEBSITE:
Visit our web site for
product updates and
additional information.