Specifications

e-mail: [e-mail] voice: 360.854.9559 fax: [phone]
17
Site Sentinel
®
16 Installation and Operation Manual
SETUP
“I/O” Setup Page
The following terms and ideas will help in the configuration of this device.
Alarms: Alarms occur when an I/O Device falls into a specified threshold, this could be
an analog value going above or below a set point, a relay turning on or a digi-
tal input going high. Each I/O Device can be configured to send Emails when
an Alarm occurs.
Emails: Each I/O device can be configured to send an email up to 8 email recipients
whenever the device enters or exits an alarm condition. Some devices have
multiple alarm conditions, such as a High and a Low alarm state. If the device
is configured to send an Exit email then the recipients list that was used for
entering the alarm state will also be used when exiting the alarm state.
Logs: Each I/O device can be enabled for logging. Logging is configured on the
Email/Network Setup page and can be setup to send snapshots of the system at
periodic intervals. Only I/O devices enabled for Logging will be included in
this snapshot
On the I/O Setup screen, choose from the top drop-down box the device to configure.
Metering/Temperature
On the Metering/Temperature screen, select either Metering or Temperature from the
second drop-down box.