Specifications
Tool & Die: 1631* Solid or Stranded Wire, 24-14 AWG Open Barrel Contact Pins 24-22/18-14 F-Type Molex/Waldom/Leoco Type Conn.
Die Set: NONE (.20-2.5 mm
2
) (.20-.34/.75-2.5 mm
2
)
Tool & Die: 1645* Solid or Stranded Wire, 30-18 AWG Open Barrel Contact Pins 30-24/22-18 F-Type Molex/Waldom/Leoco Type Conn.
Die Set: NONE (.05-.75 mm
2
) (.05-.20/.34-.75 mm
2
)
Tool & Die: 1646* Solid or Stranded Wire, 28-20 AWG Open Barrel D-Subminiature 28-24/22-20 F-Type Standard D-sub Contacts
Die Set: NONE (.08-.5 mm
2
) (.08-.2/.34-.5 mm
2
)
Tool & Die: 1670 Solid or Stranded Wire, 28-18 AWG Open Barrel EDAC Contacts 28-24/22-18 EDAC/ELCO Rack & Panel Contacts
Die Set: NONE (.08-.75 mm
2
) (.08-.2/.34-.75 mm
2
)
NOTE: For the above, the pin AWG size must be inside the range of the crimp area AWG size to work. For example, if the area is for 28-24 AWG, the pin must have an AWG rating of between 28-24. No smaller and no larger.
Example: 28-22 AWG rated pin will not work, it is too large in size.
99
solutions www.paladin-tools.com
▼
Tool & Die: 1618* Solid or Stranded Wire, 20-10 AWG Non-Insulated Terminals and Lugs 12-10/16-14/20-18 Indent For Standard Commercial Terminals
Die Set: NONE (.5-6 mm
2
) (4-6/1.5-2.5/.5-.75 mm
2
)
Part Numbers Type(s) Connector Type(s) Crimp Sizes and Type Connector Manufacturers or Remarks
Non-Insulated Terminal Crimpers
Tool & Die: 1605* Solid or Stranded Wire, 22-14 AWG Insulated Terminals and Lugs 16-14 (Blue)/22-18 (Red) Terminal-Elliptical For Standard Commercial Terminals
Die Set: NONE (.34-2.5 mm
2
) (1.5-2.5/.34-.75 mm
2
)
Insulated Terminal Crimpers
Open Barrel Contacts and Terminals Crimpers
Tool & Die: 1647 Solid or Stranded Wire, Insulated & Non-Insulated Ferrules 20-10 Trapezoid For DIN or US Type Wire Ferrules
Die Set: 2681 20-10 AWG (.5-6 mm
2
) (.50-6 mm
2
)
Tool & Die: 1648* Solid or Stranded Wire, Insulated & Non-Insulated Ferrules 20-12 Trapezoid For DIN or US Type Wire Ferrules
Die Set: NONE 20-12 AWG (.5-4 mm
2
) (.50-4 mm
2
)
Wire Ferrule Crimpers
* The die sets for these tools are NOT removable or interchangeable. Removal of the die sets will void the warranty and cause the tool to lose calibration.
7 Quick Guide & Reference 07 FINAL:54177_p001_019_out 10/19/07 10:04 AM Page 99