Specifications

e-mail: [e-mail] voice: 360.854.9559 fax: [phone]
39
ADMS 44.22 Installation and Operation Manual
OPERATION
outputs.
[x] 0 = Un-dim (reset gain to unity); 1 = Dim
DML[ic][x] Set Dim Level
Sets the dim level for one or all input channels. The dim level for an input
is used for dimming the input in both outputs 1 and 2.
[x] Dim Range = 0.0 ? -20.0 (dB)
DIMD Display Dim Settings
Returns the dim settings for all input channels in a text-readable format:
Analog Input 1:-10.0
Analog Input 2:-10.0
Analog Input 3:-10.0
Analog Input 4:-10.0
Digital Input 1:-10.0
Digital Input 2:-10.0
Digital Input 3:-10.0
Digital Input 4:-10.0<CR><LF>
4.14 Audio Switcher: Fade Commands
Fade commands are modal. Fading an input up or down in Interlock and Overlap
Modes initiates and automatic crossfade by fading down any connected
inputs at the same rate.
FD[ii] Fade Down Input In Output 1 (ACS 8.2)
Fades a single input down in Output 1 only.
FU[ii] Fade Up Input In Output 1 (ACS 8.2)
Fades a single input up in Output 1 only.
FUD[ic][oc][x] Fade Input In Output
Fades a single input up or down in a single output to at the rate specified by
the FDL command. The FDL command can also be applied to a single input
on both outputs 1 and 2, all inputs on a single output, or all inputs on both
outputs.
[x] 0 =Fade Down; 1 = Fade Up
FDL[x] Set Fade Rate
Sets the fade rate for all channels. Fade rate applies for both fade up and fade
down commands. When a fade is applied to a dimmed channel, the fade
times are adjusted to match the time taken to fade between the same gain lev-
els on a non-dimmed channel.
[x] Fade Rate Range = 0.5 ? 10.0 (seconds)