Specifications

e-mail: [e-mail] voice: 360.854.9559 fax: [phone]
36
ADMS 44.22 Installation and Operation Manual
OPERATION
is in GPO Mode.
PLF Load Factory Default Settings
Loads the factory default settings for the unit. Identical to the CDEF com-
mand.
PSU Save User Preset
Stores the current unit parameter settings into user preset memory. All
parameters listed in the factory default settings table are stored into the user
preset.
PLU Load User Preset
Loads the user preset from memory. If there is a conflict between a between
a parameter setting in the user preset and the current operating mode of the
unit (for example, a Master is changed to a Slave or visa versa), then the fac-
tory default for that parameter for the current mode will be loaded.
4.10 Audio Switcher: Non-Modal Connect Commands
Non-modal connect commands connect inputs to outputs without affecting any other
connections; they behave identically in Mix, Interlock, and Overlap Modes. For
example, issuing a non-modal connect command in Interlock Mode allows two (or
more) inputs to be connected to the same output simultaneously without the existing
input connection(s) being muted, effectively ‘overriding’ Interlock Mode.
F[xxxxxxxx] Set All Inputs (ACS 8.2)
Sets the input/output connection state for all either input channels at once.
Command arguments represent inputs 1 through 8 from L to R.
[x] A = Muted; B = Connect to Output 1 only; C = Connect to Output 2
only; D = Connect to Outputs 1 & 2
CONN[ic][oc]Connect Input To Output
Connects a single input to a single output. The CONN command can also
connect a single input to both outputs, all inputs to a single output, or all
inputs to both outputs.
[ii]3 Connect Input To Output 1 (ACS 8.2)
Connects a single input to Output 1 only.
[ii]4 Connect Input To Output 2 (ACS 8.2)
WEBSITE:
Visit our web site for
product updates and
additional information.