Specifications

e-mail: [e-mail] voice: 360.854.9559 fax: [phone]
20
ADMS 44.22 Installation and Operation Manual
INSTALLATION
Master/Slave Mode (SW9)
Sets up the unit to run in Master or Slave Mode. In Master Mode, the unit acts as
Single/Dual Unit Operation (SW10)
When a unit is set to Master Mode, the Single/Dual Unit switch determines whether
the Master receives audio inputs from the Interconnect port. In a Master/Slave
setup, this switch must be set to Dual to receive audio from the Slave. When the unit
is a stand-alone Master, then this switch must be set to single. In Slave mode this
switch is ignored.
2.14 Power Supply
Install the 7-pin DIN power connector into the power receptacle on the ADMS
44.22. When ready, plug the power supply into the appropriate AC receptacle.
CAUTION!
Failure to set SW10 to
single when operating
as a stand-alone
Master may cause spu-
rious noise to appear in
outputs 1 and/or 2
coming from the unter-
minated LVDS
Interconnect port input.
WEBSITE:
Visit our web site for
product updates and
additional information.