Specifications

e-mail:
[e-mail]
voice:
360.854.9559
fax:
866.783.1742
14
DAS 8.4 Plus Installation and Operation Manual
INSTALLATION
Type *0MM, follow the prompts on the pop-up menu.
Menu Mode:
The command to enter menu mode starts with an asterisk (“*”) followed by the
device (ID) address as a single decimal digit, then the MM command.
NOTE: Commands you type will NOT be seen, unless you turn “Echo On” in
HyperTerminal. The menu mode displays advanced configuration parameters.
Unit ID, Baud rate and other configurations are set via the on-board dipswitches
(SW16) at the rear of the unit.
Broadcast Tools® DAS 8.4 Plus v 1.9 - Setup Menu
1 - Set PIP Minimum (0 - 2.55 sec) - Now: 0.02
2 - Set Remote Mode Open Collector Mode - Now: "Follow"
3 - Set Silence Sense Acquire Delay (sec) - Now: 10
4 - Set Silence Sense Restore Delay (sec) - Now: 10
A - Save Current Channel State for Power Up
C - Show Current Configuration
F - Set Factory Defaults
Enter Selection, or Q to quit:
Serial Burst Mode Commands:
Burst mode allows a computer or ASCII terminal to control and interrogate
the unit. This section defines all burst mode commands. Each burst mode com-
mands starts with an asterisk (“*”). Next is a single decimal digit that corresponds
to the unit (ID) address 0-7. Following that are one or more ASCII characters spec-
ifying the command. No carriage-return or line-feed is required to terminate the
command except for those few commands of variable length, if the maximum length
is not sent. If the command requested a response, the response will consist of an
upper case “S”, followed by the unit address, and then the specific response. If
acknowledgements are enabled, successful commands are responded to with “RRR”
while errors get an “EEE” response. The syntax of each command is given below.
The syntax shows the command exactly as it should be sent, except that lower case
characters represent values that should be substituted: