User's Manual

6051412900 Rev -

GETTING STARTED

Installing the Transmitter on the Backpack

• Orient the CCII so that it will mount onto the backpack with the Antenna facing up.

• Align the three mounting pins on the back of the CCII with the receptacles on the backpack.

• Slide the CCII into to the receptacle until it is locked in place. No orange will show from under the latch.

• Use the belt to further secure the CCII in place.

• Carefully attach the BMS supplied antenna with integrated extension shaft to the antenna connector on the top of the

CARRY-CODER II. This antenna extension shaft ensures that the transmitted signal is sent out into unobstructed space for

propagation of the COFDM signal. In addition this shaft ensures the safety of the operator in accordance to FCC and CE

safe emissions requirements.

• Connect the interface cables from the camera to the appropriate CARRY-CODER II connector(s).

Installing the Battery on the Backpack

• Slide the battery in to the receptacle located underneath the CCII until it locks into place

• Connect the power cable coming from the backpack battery connector socket to the CARRY-CODER II.

• Switch on the power for the camera and the CARRY-CODER II.

When the CARRY-CODER II is used in the camera mount or the backpack configuration the system must be used

with the BMS supplied antenna that has an integrated shielded antenna extender in order to meet FCC and CE safe

emissions requirements.

Please note that the CARRY-CODER II can be powered from an external supply source (i.e., a battery belt or the

backpack battery) instead of an attached battery. For this purpose, the CARRY-CODER II provides a separate power

connector and a switch to select the docked battery or a separate DC power source. The benefit provided by using

the backpack is the efficient use of individual batteries, obtaining optimal battery life