User's Manual

Broadcast Microwave Services, Inc. – 12367 Crosthwaite Circle – Poway, CA 92064 10
Phone: [phone] - Fax: [phone]
Email: [e-mail] Web: www.bms-inc.com
• Regardless of the mobile and fixed applications the installation procedure for transmitter site will be similar as explained in
the following section:
Installation Procedure
The 4GHz Carry-Coder II with Power Amplifier can be installed inside a vehicle such as a truck. The symbolic diagram of the
installation is given in Figure 3. The installation procedure is as follows:
1. Install the omni-directional antenna on the vehicle roof-top using the brackets and instructions that are supplied in the
accessory kit.
2. Secure the Carry-Coder II transmitter and the Power Amplifier inside the truck. The two units may be one or 2 feet apart.
3. To ensure sufficient ventilation, at least 3” clearance is recommended from each side of the units.
• Using N-type coaxial cable (about 3 feet long) connect the output of the Carry-Coder II transmitter to the input of the Power
Amplifier.
• Using Coaxial cable and N to SMA adaptor, connect the output of the Power Amplifier to the SMA input port of the omni
antenna.
• Using the special power cords connect the Transmitter and the Power Amplifier to the 12V DC voltage.
• Connect the interface cables from the camera to the appropriate CARRY-CODER II connector(s).
• Using the supplied Remote Control Display, set the Transmitter frequency, power, modulation scheme …etc. as will be
explained in the next section.
Installing the Battery on the Carry-Coder II
The Carry-Coder II can be run by its own battery as well. The procedure for battery installation is as follows:
• Slide the battery in to the receptacle located underneath the CCII until it locks into place
• Connect the power cable coming from the battery connector socket to the CARRY-CODER II.
• Switch on the power for the camera and the CARRY-CODER II.