User's Manual

15
3.2 Mounting Instructions 5 Controlling the System
PROGRAMMING THE TRANSMITTER
The connector labelled “REMOTE” on the control panel is used to connect a
computer through a special cable.
The transmitter is pre-configured by BMS. In case that you desire to modify
the settings of the transmitter please contact BMS customer service.
ALARMS
In case of malfunction those are indicated by the transmitter.
 “COM” alarm is shown when the communication between the transmitter and
the control panel is missing. Switch the system off and check all cabling.
 “VIDEO FAIL” alarm is shown when no video signal is available on the video
inputs. Check all cabling and make sure your video source is working
properly.
 “ANT FAIL” alarm is shown when the antenna is not working properly or not
connected. Check the antenna cabling.
Caution
If there is no antenna connected to the transmitter the system may get
damaged.
 “RF FAIL” alarm is shown when the power amplifier does not work properly or
the system is overheating. Make sure cooling air flows properly and the
ventilation openings are not choking.
Note
If the problem persists please contact BMS customer service.